LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2486 (Engine Controls - Fuel Charging System & Fuel Control System -- Escape Hybrid & Mariner Hybrid) >> Removal And Installation >> Fuel Pump Control Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
    2. NOTE: The Fuel Pump (FP) control module is located near the left rear side of the fuel tank.
  2. Disconnect the FP control module electrical connector.
    3. NOTE: Do not overtighten the fasteners or damage will occur.
  3. Remove the 2 bolts and the FP control module.
    • To install, tighten to 5 Nm (44 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals