LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2477 (Engine Cooling System - (Except Hybrid)) >> Removal And Installation >> Radiator - 2.5L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the cooling fan motor and shroud. For additional information, refer to COOLING FAN MOTOR AND SHROUD .
  3. Disconnect the upper radiator hose from the radiator.
  4. Disconnect the lower degas bottle-to-radiator hose from the radiator.
  5. Disconnect the lower radiator hose from the radiator.
  6. Remove the 2 A/C condenser-to-radiator bolts and position aside the A/C condenser.
    • To install, tighten to 8 Nm (71 lb-in).
  7. Remove the radiator.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals