Coolant Pump Belt: Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Install the coolant pump belt on the coolant pump pulley and position it on the camshaft pulley.

Fig 1: Locating Coolant Pump Belt
Courtesy of FORD MOTOR CO.

NOTE: Do not use any screwdrivers, pliers or other metal objects that could cause damage to the belt or camshaft pulley while installing the belt.

Fig 2: Rotating Crankshaft To Coolant Pump Belt

Courtesy of FORD MOTOR CO.

Rotate the crankshaft clockwise to seat the coolant pump belt on the camshaft pulley.
Install the RH lower splash shield, pin-type retainer and 5 bolts.
- Tighten to 9 Nm (80 lb-in).