LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2466 (Wiper System & Washer System) >> Diagnosis And Testing >> Wipers and Washers >> Pinpoint Tests >> Pinpoint Test B: The Wipers are Inoperative - Rear Window >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Under normal operation, the rear window wiper motor receives power through circuits SBP19 (BU/RD) and CBP43 (GY). The rear window wiper motor is grounded through circuit GD183 (BK/WH). The rear window wiper motor receives open and ground inputs from the multifunction switch through circuits CRW20 (GY/YE) and CRW21 (YE/VT) to activate the wiper to the appropriate modes. The multifunction switch supplies a ground input to the rear wiper motor on circuit CRW21 (YE/VT) when INT 1 is selected. The multifunction switch supplies ground to the rear wiper motor on circuits CRW21 (YE/VT) and CRW20 (GY/YE) when INT 2 is selected.

This pinpoint test is intended to diagnose the following: 

scientia non olet · About LEMON Manuals