LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2457 (Anti-Theft System - Passive Anti-Theft System (Pats) - (Hybrid)) >> Removal And Installation >> Passive Anti-Theft System (PATS) Transceiver >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column opening cover. For additional information, refer to INSTRUMENT PANEL -- EXPLODED VIEW .
  2. Remove the 3 screws and the lower steering column shroud.
  3. Using a suitable tool such as a dentist pick, release the 2 tabs and remove the Passive Anti-Theft System (PATS) transceiver.
    • Disconnect the electrical connector.
    4. NOTE: Replacement of the PATS  transceiver does not require the PATS  keys to be programmed into the Instrument Cluster (IC) again.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals