Drive Pinion Seal: Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure that the mating surface is clean before installing the new seal.

Fig 1: Identifying Pinion Sealer Installer

Courtesy of FORD MOTOR CO.

Using the Pinion Drive Seal Installer, install the pinion seal.

NOTE: Lubricate the pinion flange with grease.

Fig 2: Identifying Index-Mark On Pinion And Flange

Courtesy of FORD MOTOR CO.

Line up the index marks and position the pinion flange.
Using the Drive Pinion Flange Holding Fixture, install a new pinion nut.
- Tighten to 244 Nm (180 lb-ft).
  
  Fig 3: Identifying Drive Pinion Flange Holder Fixture
  Courtesy of FORD MOTOR CO.
Line up the index marks and position the rear driveshaft and U-joint flange.
- Install the 4 new bolts.
- Tighten to 70 Nm (52 lb-ft).
  
  Fig 4: Locating Index Marks On Rear Driveshaft And U-Joint Flange
  Courtesy of FORD MOTOR CO.