Pinpoint Test E: The Speedometer Is Inoperative

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

E1 RETRIEVE THE RECORDED DTCs FROM THE PCM KOEO AND TCM SELF-TESTS
- Check for recorded DTCs from the PCM Key ON Engine OFF (KOEO) and TCM self-tests.
- Are any PCM or TCM DTCs recorded?
- Yes: REFER to the INTRODUCTION - GASOLINE MODELS .
- No: GO to E2 .
E2 CARRY OUT THE SPEEDOMETER ACTIVE COMMAND USING THE SCAN TOOL
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: IC DataLogger.
- Select the IC speedometer (SPDOMETER) active command. Command the speedometer on and off while monitoring the speedometer.
- Does the speed begin at 0 km/h (0 mph) move to 193 km/h (120 mph) and return to 0 km/h (0 mph)?
- Yes: GO to E3 .
- No: INSTALL a new IC . REFER to INSTRUMENT CLUSTER (IC) . TEST the system for normal operation.
E3 RETRIEVE THE RECORDED DTCs FROM THE IC SELF-TEST
- Check for recorded IC DTCs from the self-test.
- Are any DTCs recorded?
- Yes: For DTC U0100, GO to PINPOINT TEST AU .
  For DTC U0101, GO to PINPOINT TEST AV .
  
  For all other DTCs, REFER to DTC CHARTS .
- No: INSTALL a new IC . REFER to INSTRUMENT CLUSTER (IC) . TEST the system for normal operation.