LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2441 (Information Center - Instrumentation, Message Center And Warning Chimes) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test BE: DTC U0163 >> Pinpoint Test Be: DTC U0163

Pinpoint Test Be: DTC U0163

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. BE1 VERIFY THE CUSTOMER CONCERN 
    • Ignition ON.
    • Verify that there is an observable symptom present.
    • Is an observable symptom present? 
    • Yes:  GO to BE2  .
    • No:  The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  2. BE2 CHECK THE COMMUNICATION NETWORK 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: Network Test.
    • Carry out the network test.
    • Does the ACM pass the network test? 
  3. BE3 RETRIEVE THE RECORDED DTCs FROM THE IC SELF-TEST 
    • Check for recorded IC  DTCs from the self-test.
    • Is DTC B1317 or DTC B1318 recorded? 
  4. BE4 RECHECK THE IC DTCs 
    NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI  may not have been carried out.
    • Clear the DTCs. Repeat the IC  self-test.
    • Is DTC U0163 still present? 
    • Yes:  INSTALL a new ACM  . CLEAR the DTCs. REPEAT the IC  self-test.

      If DTC U0163 is still present, INSTALL a new IC  . REFER to INSTRUMENT CLUSTER (IC) . TEST the system for normal operation.

    • No:  The system is operating correctly at this time. The DTC may have been set due to high network traffic.
scientia non olet · About LEMON Manuals