Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTE:
Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
- Remove the brake shoes. For additional information, refer to BRAKE SHOES .
- Disconnect the brake tube fitting.
- To install, tighten to 18 Nm (159 lb-in).
- Remove the 2 wheel cylinder bolts and remove the wheel cylinder.
- To install, tighten to 11 Nm (97 lb-in).
- To install, reverse the removal procedure.
- Bleed the wheel cylinder. For additional information, refer to BRAKE SYSTEM BLEEDING for Component Bleeding.