LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2413 (Automatic Transmission - 6F35) >> In-Vehicle Repair >> Turbine Shaft Speed (TSS) Sensor >> Installation

Turbine Shaft Speed (TSS) Sensor: Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the TSS  sensor, the bolt and connect the TSS  electrical connector.
    • Tighten to 10 Nm (89 lb-in).
      Fig 1: Locating Turbine Shaft Speed (TSS) Electrical Connector And Bolt
      G06376902Courtesy of FORD MOTOR CO.
  2. Install the LH splash shield and the retainers.
    Fig 2: Locating LH Splash Shield Retainers
    G06376903Courtesy of FORD MOTOR CO.
  3. Fill with clean transmission fluid to the correct level.
scientia non olet · About LEMON Manuals