LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2410 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Valve Cover - RH >> Removal

Valve Cover - RH: Removal

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material (including any material created while cleaning gasket surfaces) that enters the oil passages, coolant passages or the oil pan may cause engine failure.
  1. Remove the RH ignition coil-on-plugs. For additional information, refer to IGNITION COIL-ON-PLUG .
  2. Detach the 3 main engine control wiring harness retainers from the valve cover stud bolts.
  3. Detach the 3 main engine control wiring harness retainers from the valve cover.
  4. Disconnect the Variable Camshaft Timing (VCT) electrical connector.
  5. Detach the Crankshaft Position (CKP) wiring harness retainer from the stud.
  6. Remove the 11 bolts, 3 stud bolts and the valve cover.
    • Remove and discard the gasket.
scientia non olet · About LEMON Manuals