LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Cruise Control Systems) >> System Tests >> Test H: Cruise Indicator Always On (Expedition)

Test H: Cruise Indicator Always On (Expedition)

WARNING: This page is about a different car, the 2002 Lincoln Navigator, 2002 Ford Expedition, 2001 Lincoln Navigator, and 2001 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to LOCK position. Disconnect speed control servo harness connector C157. Speed control servo is located on left side of engine compartment. Turn ignition switch to RUN position. If CRUISE indicator is always illuminated, go to next step. If CRUISE indicator is not always illuminated, replace speed control servo. See SPEED CONTROL SERVO  under REMOVAL & INSTALLATION.
  2. Turn ignition switch to LOCK position. Disconnect instrument cluster harness connector C238. Measure resistance between ground and speed control servo harness connector C157 terminal No. 1 (Orange/Light Blue wire). See Figure If resistance is more than 10 k/ohms, repair instrument cluster concern. See appropriate ANALOG INSTRUMENT PANELS - EXPEDITION & NAVIGATOR article. If resistance is 10 k/ohms or less, repair short to ground in Orange/Light Blue wire. See WIRING DIAGRAMS .
scientia non olet · About LEMON Manuals