Special Tool(s)

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

SPECIAL TOOLS DESCRIPTION TABLE

Courtesy of FORD MOTOR CO.

Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool

NOTE: This procedure is used when a customer needs to have an additional key programmed into the vehicle without erasing stored key codes, but 2 programmed keys are not available. This procedure is also useful when attempting to determine if an ignition key is damaged, as a new key can be installed without erasing keys or without having 2 programmed keys available.

NOTE: Before programming, the new key must have the correct mechanical cut for the ignition lock cylinder.

NOTE: If 8 keys are already programmed, this procedure does not allow any more ignition keys to be programmed. The number of keys that are programmed into the Passive Anti-Theft System (PATS) can be determined by viewing the Instrument Panel Cluster (IPC) PID N_KEYCODE.

Turn the new key to be programmed from the OFF position to the ON position.
From the scan tool, enter TOOLBOX. Select BODY-SECURITY-PATS Functions and follow the Integrated Diagnostic System (IDS) on-screen instructions to ENTER SECURITY ACCESS. For additional information, refer to ANTI-THEFT SECURITY ACCESS .
From the scan tool menu select: "program additional ignition key".
NOTE: Make sure the selection made is "program additional ignition key". If the "Ignition Key Code Erase" selection is made, all of the keys are erased from the system.
Turn the key to the OFF position and disconnect the scan tool.
Start the vehicle with the new PATS key. The vehicle now starts with the new PATS key and also with the original PATS keys. If it is an IKT key, verify the RKE functions (if there are 4 or fewer IKT keys programmed).