Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
If equipped, remove the 7 screws and the underbody cover.

Fig 1: Locating Underbody Cover & Screws
Courtesy of FORD MOTOR CO.
Position the block heater heat shield aside.
Remove the block heater heat shield.
Disconnect the block heater electrical connector.
NOTE: Make sure that the block heater wiring is routed and secured away from rotating or hot components, or damage to the wiring can occur.
Remove the block heater.
- To install, tighten to 20 Nm (177 lb-in).
To install, reverse the removal procedure.
Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .