Normal Operation
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
The yaw rate sensor, lateral accelerometer and longitudinal accelerometer are contained in Restraints Control Module (RCM). The RCM measures vehicle yaw rate, lateral acceleration and longitudinal acceleration and then sends the information to the ABS module along the dedicated Controller Area Network (CAN) bus, circuits VCA23 (BU/WH) and VCA24 (GN/OG). This dedicated CAN bus is used only for communication between the RCM and the ABS module. The information sent to the ABS module is used to help determine if the AdvanceTrac® system needs to be activated.
DTC DESCRIPTION TABLE
| DTC Description | Fault Trigger Conditions |
|---|---|
|
If, during normal operation or the ABS module on-demand self test the ABS module detects an open circuit, a short to voltage or a short to ground on one or both of the dedicated CAN bus circuits, or a failure of the RCM will cause the appropriate DTC will be set. |
|
If conditions exist during normal operation that prevent the AdvanceTrac® system from operating, DTC C1963 will be set. This DTC is usually set due to the steering wheel rotation sensor or the RCM being damaged or installed incorrectly. |
|
This DTC indicates that one or more of the stability/traction control system sensors internal to the RCM have failed and the RCM is transmitting on "invalid data" message. |
This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- RCM incorrectly mounted
- RCM
- ABS module