Rear Disc Brake Shield - All Wheel Drive (AWD): Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Transfer the index mark from the removed brake disc shield to the new brake disc shield.
Position the brake disc shield onto the wheel knuckle.
Align the index marks and install the brake disc shield onto the wheel knuckle using the Front Subframe Bushing Remover/Installer.

Fig 1: Identifying Front Subframe Bushing Removal/Installer

Courtesy of FORD MOTOR CO.