Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Non-Hybrid shown, Hybrid similar.

Fig 1: Identifying Instrument Panel Cluster, Lens, Mask Assembly And Screws

Courtesy of FORD MOTOR CO.

ITEM DESCRIPTION TABLE

Item	Part Number	Description
1	10849	Instrument Panel Cluster (IPC)
2	10890	IPC lens and mask assembly (Fusion and Milan)
2	10B885	IPC lens (MKZ)
3	-	Screw (1 required, non-hybrid) (4 required, hybrid)

All vehicles

Remove the Instrument Panel Cluster (IPC). For additional information, refer to INSTRUMENT PANEL CLUSTER (IPC) .
Fusion and Milan

NOTE: Make sure the screw(s) are securely tightened, but do not over-tighten to prevent stripping the screw out.

NOTE: While the IPC lens is removed, the IPC must remain with the gauges facing upward to maintain gauge calibration.
Remove the screw (non-hybrid) or the 4 screws (hybrid).
Release the 6 tabs (non-hybrid) or 8 tabs (hybrid) and remove the lens and mask assembly.
MKZ
Release the 8 tabs and remove the lens.
All vehicles
To install, reverse the removal procedure.