LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2308 (Exhaust System) >> Removal And Installation >> Catalytic Converter - 3.5L LH >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
    NOTE: Always install new fasteners and gaskets as indicated. Clean flange faces prior to new gasket installation to make sure of proper sealing.
  2. Disconnect the Catalyst Monitor Sensor (CMS) electrical connector.
  3. Remove the exhaust Y-pipe. For additional information, refer to Removal and Installation .
  4. Remove the 2 catalytic converter support bracket-to-transmission bolts.
    • To install, tighten to 48 Nm (35 lb-ft).
  5. Remove the 4 nuts and the LH catalytic converter.
    • Discard the 4 LH catalytic converter-to-exhaust manifold nuts and gasket.
    • To install, tighten to 40 Nm (30 lb-ft).
  6. To install, reverse the removal procedure.
    • Install a new gasket, nuts and studs as indicated.
scientia non olet · About LEMON Manuals