Turbine Shaft Speed (TSS) Sensor: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Install the TSS sensor and the bolt.
- Tighten to 10 Nm (89 lb-in).
Fig 1: Locating Bolt And TSS Sensor
Courtesy of FORD MOTOR CO.
Connect the TSS sensor electrical connector.

Fig 2: Locating Turbine Shaft Speed (TSS) Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
Install the LH front structure-to-subframe splash shield and the 6 pin-type retainers.

Fig 3: Locating LH Front Structure-To-Subframe Splash Shield And Pin-Type Retainers
Courtesy of FORD MOTOR CO.
Fill the transaxle with clean transmission fluid.

Fig 4: Locating Transmission Fluid Level Indicator
Courtesy of FORD MOTOR CO.
Start the engine and let it run for 3 minutes. Move the range selector lever into each gear position. Check the transmission fluid level, making sure that the transmission fluid is at the correct level.