LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2294 (Engine Mechanical - 3.5L) >> In-Vehicle Repair >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the crankshaft pulley. For additional information, refer to Removal .
  3. Using the Oil Seal Remover, remove and discard the crankshaft front seal.
    • Clean all sealing surfaces with metal surface prep.
    Fig 1: Identifying Oil Seal Remover
    G06061944Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals