LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2294 (Engine Mechanical - 3.5L) >> In-Vehicle Repair >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the Front Crankshaft Seal Installer and Crankshaft Vibration Damper Installer, install a new crankshaft front seal.
    NOTE: Apply clean engine oil to the crankshaft front seal bore in the engine front cover.
    Fig 1: Identifying Crankshaft Vibration Damper Installer And Front Crankshaft Installer
    G06061945Courtesy of FORD MOTOR CO.
  2. Install the crankshaft pulley. For additional information, refer to Installation .
scientia non olet · About LEMON Manuals