Removal And Installation
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Right outer and right inner parking aid sensors shown, left outer and left inner similar.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
- Disconnect the parking aid sensor electrical connector.
- Remove the parking aid sensor(s).
- Press the parking aid sensor retaining tabs to release the sensor(s).
- To install, reverse the removal procedure.
- Using the scan tool, verify that the parking aid sensor distance PIDs read no object present, and that the parking aid sensor attenuation PIDs read between 0.8 - 1.6 ms. If the parking aid sensor attenuation PIDs do not read between 0.8 - 1.6 ms, the paint is too thick on the sensor(s) and it will be necessary to repaint the sensor(s) as required.