LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2252 (Automatic Transmission - 5R110W (TORQSHIFT(R))) >> In-Vehicle Servicing >> Transmission Support Crossmember >> Removal

Transmission Support Crossmember: Removal

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Install a suitable high-lift transmission jack.
  3. Remove the 2 wire harness retainers from the transmission support crossmember and position the wire harness aside.
    4. Fig 1: Identifying Wire Harness Retaining Clips
    G03889060Courtesy of FORD MOTOR CO.
  4. Remove the heat shield screws.
    5. Fig 2: Heat Shield Screws
    GF0012415Courtesy of FORD MOTOR CO.
  5. Remove the LH transmission crossmember nuts.
    6. Fig 3: Identifying LH Crossmember Nuts
    G03889061Courtesy of FORD MOTOR CO.
  6. Remove the LH transmission crossmember frame bolts.
    7. Fig 4: Locating LH Crossmember Bracket
    G03889062Courtesy of FORD MOTOR CO.
  7. Remove the RH transmission crossmember nuts.
    8. Fig 5: Identifying RH Crossmember Nuts
    G03889063Courtesy of FORD MOTOR CO.
  8. Remove the RH transmission crossmember frame bolts.
    9. Fig 6: Identifying RH Crossmember Bracket
    G03889064Courtesy of FORD MOTOR CO.
  9. Remove the transmission insulator nuts and the transmission crossmember.
    10. Fig 7: Identifying Transmission Support Insulator Nuts
    G03889099Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals