LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2252 (Automatic Transmission - 5R110W (TORQSHIFT(R))) >> In-Vehicle Servicing >> Transmission Support Crossmember >> Installation

Transmission Support Crossmember: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the transmission crossmember to the transmission insulator and loosely install the nut.
    2. Fig 1: Locating Crossmember To Transmission Mount Nut
    G03889185Courtesy of FORD MOTOR CO.
  2. Install the LH transmission crossmember frame bolts.
    3. Fig 2: Locating LH Crossmember Bracket
    G03889062Courtesy of FORD MOTOR CO.
  3. Install the LH transmission crossmember nuts.
    • Tighten to 81 Nm (60 lb-ft).
    4. Fig 3: Identifying LH Crossmember Nuts
    G03889061Courtesy of FORD MOTOR CO.
  4. Install the RH crossmember frame bolts.
    5. Fig 4: Identifying RH Crossmember Bracket
    G03889064Courtesy of FORD MOTOR CO.
  5. Install the RH transmission crossmember nuts.
    • Tighten to 81 Nm (60 lb-ft).
    6. Fig 5: Identifying RH Crossmember Nuts
    G03889063Courtesy of FORD MOTOR CO.
  6. Tighten the transmission insulator nuts to 94 Nm (69 lb-ft).
    7. Fig 6: Identifying Transmission Support Insulator Nuts
    G03889099Courtesy of FORD MOTOR CO.
  7. Install the heat shield screws.
    • Tighten to 20 Nm (177 lb-in).
    8. Fig 7: Heat Shield Screws
    GF0012415Courtesy of FORD MOTOR CO.
  8. Install the wire harness and install the 2 retaining clips to the crossmember.
    9. Fig 8: Identifying Wire Harness Retaining Clips
    G03889060Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals