LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2252 (Automatic Transmission - 5R110W (TORQSHIFT(R))) >> In-Vehicle Servicing >> Internal Harness Service >> Removal

Internal Harness Service: Removal

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the solenoid body. For additional information, refer to Solenoid Body Assembly .
  2. Disconnect the transmission internal wiring harness.
    1. Remove the 2 screws.
    2. Disconnect the Transmission Fluid Temperature (TFT) sensor connector.
    3. Disconnect the solenoid connectors.
    3. Fig 1: Transmission Fluid Temperature Sensor Electrical Connector And Solenoid Electrical Connectors
    GF0006824Courtesy of FORD MOTOR CO.
  3. Remove the solenoid body connector O-ring.
    4. Fig 2: Identifying Bulkhead Connector O-Ring
    G03889120Courtesy of FORD MOTOR CO.
  4. Lift the tab twisting the solenoid body connector, and push it through the solenoid body, and remove the harness.
scientia non olet · About LEMON Manuals