Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Remove the engine cooling fan and fan shroud. For additional information, refer to ENGINE COOLING article.
Rotate the tensioner clockwise and remove the accessory drive belt from the crankshaft pulley.

Fig 1: Rotating Tensioner Clockwise

Courtesy of FORD MOTOR CO.

CAUTION: This bolt is torque-to-yield and cannot be reused. Failure to follow these instructions may result in engine damage.

Using the special tool, remove the bolt and washer and discard the bolt.

Fig 2: Holding Crankshaft Pulley Using Special Tool (303-D055)

Courtesy of FORD MOTOR CO.

Using the special tool, remove the crankshaft pulley.

Fig 3: Removing Crankshaft Pulley Using Special Tool

Courtesy of FORD MOTOR CO.