LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2241 (Automatic Transmission - 4R70E/W, 4R75E/W) >> In-Vehicle Servicing >> Transmission Insulator And Retainer >> Installation

Transmission Insulator And Retainer: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the insulator and retainer and install the bolts.
    • Tighten to 90 Nm (66 lb-ft).
    2. Fig 1: Insulator Bolts
    GF0012360Courtesy of FORD MOTOR CO.
  2. Lower the transmission while aligning the retainer studs with the holes in the crossmember. Allow the full weight of the transmission to rest on the crossmember.
    3. Fig 2: Retainer Studs
    GF0012365Courtesy of FORD MOTOR CO.
  3. Remove the high-lift transmission jack.
  4. Install the insulator and retainer to crossmember nuts.
    • Tighten to 90 Nm (66 lb-ft).
    5. Fig 3: Insulator Nuts
    GF0012361Courtesy of FORD MOTOR CO.
  5. Remove the supports and lower the vehicle.
scientia non olet · About LEMON Manuals