LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2213 (Exterior Lighting System) >> Diagnostic Tests >> Daytime Running Lamps (DRL) >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of electrical damage.
    VISUAL INSPECTION CHART

    Electrical
    • Battery junction box (BJB) fuse 3 (15A) (daytime running lamps [DRL] module)
    • Central junction box (CJB) fuse 6 (15A) (ignition switch input to DRL module)
    • Wiring, terminals or connectors
    • DRL module
  3. Make sure the headlamps operate correctly. If the headlamps do not operate correctly, refer to Headlamps  to continue diagnosis of the headlamps.
  4. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  5. If the concern is not visually evident, verify the symptom. Go to Symptom Chart .