LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Wheel Alignment Specifications & Adjustment Procedures - Specifications & Procedures -- Trucks) >> Wheel Alignment Procedures >> Camber & Caster Adjustment >> Excursion & F250/350 Super Duty (4WD)

Excursion & F250/350 Super Duty (4WD)

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2001 Mercury Villager, 2001 Mercury Mountaineer, 2001 Lincoln Navigator, 2001 Ford Windstar, and 2001 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure camber and caster to determine adjustment required. Record specifications for use in selection of camber/caster adjusters. To adjust, raise and support vehicle. Remove wheel assembly. Remove upper ball joint castle nut. Reinstall nut, leaving gap between nut and camber adjuster sleeve. Loosen lower ball joint nut. Separate spindle from axle.
  2. Remove upper castle nut. Using suitable puller, remove camber adjuster sleeve. See Fig 1. Install appropriate NEW camber adjuster sleeve. Install castle nut. Apply Threadlock & Sealer (EOAZ-199554-AA) to lower ball joint stud. Tighten lower and upper nuts to specification. See TORQUE SPECIFICATIONS .
  3. Verify camber change. Adjust as necessary. Adjust toe-in. See TOE-IN ADJUSTMENT .
Fig 1: Adjusting Camber (Excursion & F250/F350 Super Duty 4WD)
G99G03228Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals