LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2154 (Engine - 2.3L - (Hybrid)) >> In-Vehicle Servicing >> Cylinder Head >> Removal

Cylinder Head: Removal

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Do not loosen or remove the crankshaft pulley bolt without first installing the special tools as instructed in this procedure. The crankshaft pulley and the crankshaft timing sprocket are not keyed to the crankshaft. The crankshaft, the crankshaft sprocket and the pulley are fitted together by friction, using diamond washers between the flange faces on each part. For that reason, the crankshaft sprocket is also unfastened if you loosen the pulley bolt. Before any repair requiring loosening or removal of the crankshaft pulley bolt, the crankshaft and camshafts must be locked in place by the special service tools, otherwise severe engine damage can occur.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material (including any material created while cleaning gasket surfaces) that enters the oil passages, coolant passages or the oil pan can cause engine failure.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Release the fuel system pressure. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  3. Drain the engine cooling system. For additional information, refer to ENGINE COOLING - HYBRID article.
  4. Remove the timing drive components. For additional information, refer to Timing Drive Components .
  5. Remove the special tool.
    6. Fig 1: Identifying Special Camshaft Tool (303-465)
    G03898006Courtesy of FORD MOTOR CO.
  6. Mark the position of the camshaft lobes on the No. 1 cylinder for installation reference.
    7. Fig 2: Locating Camshaft Lobe
    G03898791Courtesy of FORD MOTOR CO.
    NOTE: Failure to follow the camshaft loosening procedure can result in damage to the camshafts.
    NOTE: Mark the location and orientation of each camshaft bearing cap.
  7. Remove the camshafts from the engine.
    • Loosen the camshaft bearing cap bolts, in sequence, one turn at a time until all tension is released from the camshaft bearing caps.
    • Remove the bolts and the camshaft bearing caps.
    • Remove the camshafts.
    8. Fig 3: Identifying Loosening Sequence Of Camshaft Bearing Bolts
    G03897808Courtesy of FORD MOTOR CO.
    NOTE: If the camshafts and valve tappets are to be reused, mark the location of the valve tappets to make sure they are assembled in their original positions.
  8. Remove the valve tappets.
  9. Inspect the valve tappets. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
  10. Remove the intake manifold. For additional information, refer to Intake Manifold .
  11. Remove the catalytic converter. For additional information, refer to EXHAUST SYSTEM article.
  12. Disconnect the EGR valve electrical connector.
  13. Disconnect the upper radiator hose, coolant bypass hose, heater hose and coolant vent hose from the engine coolant outlet.
  14. Remove the bolts and the cylinder head.
    • Discard the bolts and the cylinder head gasket.
scientia non olet · About LEMON Manuals