LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2153 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the crankshaft pulley. For additional information, refer to Crankshaft Pulley .
  3. Using the special tool, remove and discard the crankshaft front seal.
    4. Fig 1: Removing Crankshaft Front Seal Using Special Tool (303-409)
    GF0024224Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals