LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2152 (Engine - 2.3L - (Except Hybrid)) >> In-Vehicle Servicing >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Remove the through-bolt from the special tool.
    NOTE: Lubricate the oil seal with clean engine oil.
  1. Using the special tool, install the crankshaft front oil seal.
    2. Fig 1: Installing Crankshaft Front Oil Seal Using Special Tool
    G03897717Courtesy of FORD MOTOR CO.
  2. Install the crankshaft pulley. For additional information, refer to Lower End Components - Exploded View  and Crankshaft Pulley .
scientia non olet · About LEMON Manuals