LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Wheel Alignment Specifications & Adjustment Procedures) >> Riding Height >> Adjustment Procedures (BLACKWOOD) >> Initialize System - Clear B2140 DTC

Initialize System - Clear B2140 DTC

WARNING: This page is about a different car, the 2003 Lincoln Blackwood, 2003 Ford Pickup, 2002 Lincoln Blackwood, and 2002 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition key OFF and turn it back to RUN. Exit the vehicle, close all doors and allow the system to vent the vehicle down to kneel height (approximately 30 seconds). Connect the scan tool to the Data Link Connector (DLC) and follow the directions. Select Air Suspension Module.
    2. NOTE: Do not save rear ride heights. The air suspension module has precalibrated values already stored. Refer to Rear Ride Height Mechanical Resetting.
  2. Select the "Save Calibration Values (Store Ride Height)" scan tool command to calibrate the air suspension module. Trigger through the warning message(s) and save "initialization" (trigger from OFF to ON).
scientia non olet · About LEMON Manuals