Removal And Installation

All vehicles 

1. Remove the driver and front passenger seats. For additional information, refer to SEATING article.
2. Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
3. Remove the front door scuff plate trim panels and the lower A-pillar trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.

Vehicles with automatic transmission 

4. Detach the selector lever cable from the gearshift assembly.
   1. Disconnect the selector lever cable end from the gearshift lever.
   2. Remove the selector lever cable from the bracket.
Fig 1: Identifying Grarshift Assembly And Selector Lever Cable
Courtesy of FORD MOTOR CO.

All vehicles 

NOTE: Position the carpet to gain access to the floor ducts.
5. Separate the wiring harness from the LH floor duct and position aside.
6. Remove the LH floor duct.
7. Remove the RH floor duct pin-type retainer.
8. Remove the RH floor duct.
9. To install, reverse the removal procedure.