Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear seat cushion.
- Position the seat cushion forward.
- Release the locking tab and slide the rear seat cushion outward.

Fig 1: Identifying Locking Tab

Courtesy of FORD MOTOR CO.

Unzip the cushion cover zipper.

Fig 2: Identifying Cushion Cover Zipper

Courtesy of FORD MOTOR CO.

NOTE: Use care when separating the seat cushion trim cover from the hook-and-loop strips or the hook-and-loop strips may be torn from the seat cushion foam pad.

Invert and remove the cushion cover.

NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

To install, reverse the removal procedure.