LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2118 (Exterior Trim And Ornamentation) >> Removal And Installation >> Window Molding - Rear Door

Window Molding - Rear Door

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door glass run. For additional information, refer to GLASS, FRAMES AND MECHANISMS article.
  2. Drill out the window molding rivets.
  3. Remove the window molding.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals