Calipers & Pads: Inspection
WARNING: This page is about a different car, the 2004 Ford Ranger, 2003 Ford Ranger, and 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
Inspect the anchor plate guide pins. They should slide in and out of the anchor plates with no binding. Check the boots for cracks or tears. If the pins do not slide easily or the boots are cracked or torn, install new boots and pins. Lubricate the pins using Silicone Brake Caliper Grease and Dielectric Compound (D7AZ-19A331-A), or equivalent, meeting Ford specification ESE-M1C171-A.
Inspect the anti-rattle spring. Replace if worn or damaged. Clean the anchor plate anti-rattle clips (slipper) mating surfaces.