Removal & Installation (Transfer Case): Escape: Removal
WARNING: This page does not describe the selected car, but rather 26 other vehicles, including the 2001 Mercury Villager, 2001 Mercury Mountaineer, 2001 Ford RV Cutaway, 2001 Ford Pickup, and 2001 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support vehicle. Ensure transfer case is in Neutral. Disconnect negative battery cable. Mark drive shaft and axle flange or yoke for reassembly reference. Remove drive shafts from transfer case, and secure aside. Remove exhaust heat shields, if necessary.
- On 3.0L models, remove right side exhaust manifold. Remove crossmember brace. Remove transfer case-to-transaxle bolts. Disconnect vent tube and plug to prevent fluid loss. Remove transfer case.