168,000 Km (105,000 Mi)
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Change engine oil and install a new oil filter.
- Install a new cabin air filter (if equipped).
- Install a PCV valve on all cars and light trucks under 6,000 lb GVW (except 3V engines).
- Change rear axle fluid on vehicles equipped with DANA axles which use synthetic lubricants.
- Change premium gold engine coolant.
- Inspect steering linkage, suspension and, if equipped, driveshaft, ball joints and U-joints.
- Inspect engine coolant system and hoses.
- Inspect brake pads, shoes, rotors, drums, brake lines, hoses and parking brake system.
- Inspect halfshaft boots (if equipped).
- Inspect exhaust system and heat shields.
- Inspect engine air filter.
- Inspect automatic transmission fluid level (if equipped with an underhood fluid level indicator).
- Inspect and lubricate ball joints and U-joints (if equipped with zerk fittings).
- Inspect and lubricate 4WD front axle shaft U-joints (if equipped).
- Carry out multi-point inspection (recommended).
- Rotate tires, inspect tires for wear, measure tread depth and inspect wheel ends for end play and noise. Vehicles with dual rear wheels should only be rotated if unusual wear is noted. For vehicles with different front-to-rear tire pressures, the tire pressure must be adjusted and the tire pressure sensor training must be done.