LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2090 (Engine Controls - Powertrain DTC Charts And Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> P1501 - Vehicle Speed Sensor (VSS) Out Of Self-Test Range

P1501 - Vehicle Speed Sensor (VSS) Out Of Self-Test Range

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2008 Mercury Sable, 2008 Mercury Mountaineer, 2008 Mercury Milan, 2008 Mercury Mariner, and 2008 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P1501 - VEHICLE SPEED SENSOR (VSS) OUT OF SELF-TEST RANGE

Description:  Indicates the VSS input signal is out of self-test range. If the powertrain control module (PCM) detects a VSS input signal any time during the self-test, DTC P1501 is set and the test aborts.
Possible Causes: 
  • Noise on the VSS input signal from the radio frequency interference/electro magnetic interference (RFI/EMI)
  • External sources, such as ignition wires, the charging circuit or aftermarket equipment
Diagnostic Aids:  Verify the VSS input is 0 km/h (0 mph) when the vehicle transmission is in PARK.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
F-Super Duty   refer to PINPOINT TEST DF . refer to PINPOINT TEST DF . -
Expedition,
Navigator,
Sable,
Taurus,
Taurus X
  The powertrain control module (PCM) uses information from the anti-lock brake system (ABS) module and the transmission control module (TCM) to calculate vehicle speed. Check these modules for DTCs.
All others   refer to PINPOINT TEST DP . refer to PINPOINT TEST DP . -