P0537 - A/C Evaporator Temperature Sensor Circuit Low
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2008 Mercury Sable, 2008 Mercury Mountaineer, 2008 Mercury Milan, 2008 Mercury Mariner, and 2008 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P0537 - A/C EVAPORATOR TEMPERATURE SENSOR CIRCUIT LOW
| Description: | Indicates the ACET signal input was less than the self-test minimum. The self-test minimum is 0.13 volts. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | The powertrain control module (PCM) sources a low current 5 volts on the ACET circuit (this voltage can be measured with the sensor disconnected). As the A/C evaporator air temperature changes, the ACET circuit resistance to SIG RTN (ground) changes (which changes the voltage the PCM detects). When the ACET signal is detected below the self-test minimum, check for shorts to the SIG RTN or ground, which would pull the voltage low. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | refer to PINPOINT TEST DJ . | |||