P0325 - Knock Sensor 1 Circuit (Bank 1)
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2008 Mercury Sable, 2008 Mercury Mountaineer, 2008 Mercury Milan, 2008 Mercury Mariner, and 2008 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P0325 - KNOCK SENSOR 1 CIRCUIT (BANK 1)
| Description: | The KS detects vibrations upon increase and decrease in engine RPM. The knock sensor generates a voltage based on this vibration. A DTC is set if the voltage goes outside a calibrated level. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | A knock sensor voltage greater than 0.5 volt with the key ON engine OFF indicates a concern is present. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | - | refer to PINPOINT TEST DG . | refer to PINPOINT TEST DG . | |