LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (Disc Brakes - Excursion, F250-F550 Super Duty) >> Removal & Installation >> Disc Brake Calipers & Pads >> Installation

Disc Brake Calipers & Pads: Installation

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2003 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not allow grease, oil, brake fluid or other contaminants to contact the pad lining material. Do not install contaminated pads.
  1. Install the disc brake caliper anchor plate stainless steel rail clips. Install the pads.
  2. If necessary, install the "V" springs.
  3. Compress the caliper pistons into caliper.
  4. Install the disc brake caliper. Install the disc brake caliper pin bolts. Install stone shield on rear forward-of-axle models.
  5. On all models, install the wheel and tire assembly. Lower vehicle.
  6. Fill the brake master cylinder reservoir with DOT 3 motor vehicle brake fluid. Install the brake master cylinder filler cap.
  7. Bleed brake system as necessary. See BLEEDING BRAKE SYSTEM .
Fig 1: Identifying Rear Disc Brake Caliper Stone Shield
G00299601Courtesy of FORD MOTOR CO.
Fig 2: Inspecting Caliper For Leakage
G00297488Courtesy of FORD MOTOR CO.
Fig 3: Identifying "V" Springs
G00299604Courtesy of FORD MOTOR CO.
Fig 4: Identifying Anchor Plate Stainless Steel Rail Clips
G00299609Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals