LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (Disc Brakes - Excursion, F250-F550 Super Duty) >> Bleeding Brake System >> Component Bleeding >> Caliper

Component Bleeding: Caliper

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2003 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: It is not necessary to do a complete brake system bleed if only the disc brake caliper was disconnected.
  1. Place a box end wrench on the disc brake caliper bleeder screw. Attach a rubber drain tube to the disc brake caliper bleeder screw, and submerge the free end of the tube in a container partially filled with clean brake fluid. See Fig 1.
  2. Have an assistant pump the brake pedal and then hold firm pressure on the brake pedal.
  3. Loosen the disc brake caliper bleeder screw until a stream of brake fluid comes out. While the assistant maintains pressure on the brake pedal, tighten the disc brake caliper bleeder screw. Repeat until clear, bubble-free fluid comes out. Refill the brake master cylinder reservoir as necessary.
  4. Tighten the caliper bleeder screw.
Fig 1: Bleeding Calipers (Typical)
G95A27623Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals