LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2074 (Parking Brake System And Actuation) >> Removal And Installation >> Parking Brake Control >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
  2. Remove the parking brake control boot.
    • Pull the parking brake control boot up and over the lever.
  3. Release the parking brake control.
  4. Remove the front cable adjusting nut.
  5. Remove the 4 parking brake control bolts.
    • To install, tighten to 24 Nm (18 lb-ft).
  6. Disconnect the warning indicator switch electrical connector.
  7. Remove the parking brake control.
    • Disconnect the front parking brake cable.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals