LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Disc Brakes & Drum Brakes) >> Overhaul >> Disc Brake Caliper >> Reassembly

Disc Brake Caliper: Reassembly

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, 2004 Ford Cutaway, and 2003 Ford RV Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply clean brake fluid to NEW piston seal, and install in caliper bore groove. Apply clean brake fluid to caliper bore. Coat piston and outside beads of dust boot with clean brake fluid.
  2. Push piston through boot until boot is around bottom (closed end) of piston. See Fig 1 or Fig 2 . Position piston and boot directly over caliper bore. Spread dust boot over piston as it is installed.
  3. With bead seated in groove, carefully press straight down on piston until it bottoms in caliper bore. Do NOT cock or jam piston in caliper bore. If necessary, use a "C" clamp and a block of wood to bottom piston in caliper bore.
Fig 1: Exploded View Of Single Piston Caliper
G95J28067Courtesy of FORD MOTOR CO.
Fig 2: Identifying Dual Piston Caliper Components
G00294651Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals