LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2038 (Exterior Lighting System) >> Removal And Installation >> Reversing Lamp Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the reversing lamp switch electrical connector.
  2. Remove the reversing lamp switch.
    • To install, tighten to 24 Nm (18 lb-ft).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals