LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 200 (Engine Controls - Removal & Installation - Gasoline) >> Fuel Systems >> Fuel Injection Supply Manifold & Injectors >> Installation (4.6L & 5.4L)

Installation (4.6L & 5.4L)

WARNING: This page is about a different car, the 2003 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install NEW injector "O" rings and lubricate with clean engine oil. Install injectors in fuel injection supply manifold. Install fuel injection supply manifold and 4 retaining bolts. Tighten bolts to specification. See TORQUE SPECIFICATIONS .
  2. Connect vapor management valve hose.
  3. Install the following EGR components:

    4.6L Engines

    • EGR tube to EGR valve and exhaust manifold.
    • EGR transducer hoses.

    5.4L Engines

    • EGR tube to EGR valve and exhaust manifold.
    • EGR transducer hoses.
    • EGR vacuum hose.

    Tighten EGR tube fittings to specification. See TORQUE SPECIFICATIONS .

  4. Install crankcase vent connector and hose. Connect 8 fuel injector electrical connectors and fuel pressure regulator vacuum hose.
  5. Connect fuel lines. See FUEL LINE CONNECTORS . On vehicles with dual batteries, see DUAL BATTERIES  under MISCELLANEOUS.
scientia non olet · About LEMON Manuals