Wheel and Tire: Installation
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the wheel mounting surfaces.
- Install the wheel and tire assembly.
- Install the 5 wheel nuts.
- Tighten the wheel nuts in a star pattern.
- Tighten to 133 Nm (98 lb-ft).
WARNING:
When a wheel is installed, always remove any corrosion, dirt or foreign material present on the mounting surface of the wheel and the mounting surface of the wheel hub, brake drum or brake disc. Make sure that any fasteners that attach the rotor to the hub are secured so they do not interfere with the mounting surfaces of the wheel. Failure to follow these instructions when installing wheels may result in the wheel nuts loosening and the wheel coming off while the vehicle is in motion, which could result in loss of control, leading to serious injury or death to vehicle occupant(s).
WARNING:
Retighten wheel nuts within 160 km (100 mi) after a wheel is reinstalled. Wheels can loosen after initial tightening. Failure to follow this instruction may result in serious injury to vehicle occupant(s).
CAUTION:
Failure to tighten the wheel nuts in a star pattern may result in high brake disc runout, which will speed up the development of brake roughness, shudder and vibration.