Stub Shaft Pilot Bearing and Seal: Installation
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- To install the bearing, use the special tools and install the stub shaft pilot bearing.
- Using the special tools, install the stub shaft pilot bearing housing seal.
- Install the halfshaft assembly. For additional information, refer to REAR DRIVE HALFSHAFTS article.
NOTE:
Lubricate the new stub shaft pilot bearing with rear axle lubricant.
NOTE:
Lubricate the new stub shaft pilot bearing housing seal with grease.
CAUTION:
Inspect the inboard CV joint seal journal for rust or nicks/scratches prior to installing the halfshaft. If necessary, polish the seal journal with fine crocus cloth.